Mega System Tech NET101 Manuel de l'opérateur télécharger pdf (Page 175)

Left bulb carrier illustrated as example

Retaining tab

;

Electrical connector

Press retaining tab : in the center of

the bulb carrier upwards.

Pull the bulb carrier out of the tail lamp

housing.

Left bulb carrier with bulb sockets (right bulb

carrier in reverse)

Retaining tab

Brake, tail, turn signal and side marker

lamp bulb

Backup lamp bulb

Depending on which bulb needs to be

replaced, press gently onto bulb =

or ? and turn it counterclockwise.

Pull the bulb out of the bulb socket.

Installing: Insert the new bulb into the

bulb socket.

Press gently onto the bulb and turn it

clockwise until it engages.

Insert the bulb carrier into the tail lamp

housing.

Press gently onto the bulb carrier.

Let retaining tab : engage.

Fold the damping material backward, if

necessary.

Reinstall the side cover in the cargo

compartment.

High mounted brake lamp

Removing: Unscrew retaining screws :.

Remove high mounted brake lamp ;.

Detach electrical connector ? from bulb

socket =.

Turn the bulb counterclockwise and pull

it out of its socket.

Installing: Install in the reverse order.

License plate lamps

Warning!

High outside temperature, stop-and-go

traffic, driving on long uphill grades, or

driving at high engine speed may increase

the temperature in the engine

compartment. Therefore the area around the

air slots in the rear apron may be hot. Let

the engine cool off before touching this

area to prevent burns.

Replacing bulbs

173

>> Practical hints.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 219 220

Mega System Tech NET101 Manuel de l'opérateur Page 175

Commentaires sur ces manuels